Denver Rapid Appliance Repair provides Kenmore appliance repair throughout Denver. Our technicians have hands-on experience diagnosing and repairing Kenmore dryers, washers, refrigerators, and dishwashers — with real Denver repair examples documented on this page.
We document our Kenmore appliance repairs so you can see the actual problems we diagnose and fix. Every example below is a real service call completed by our technicians in the Denver area.
Model: 110.63952102
Problem: Dryer ran but produced no heat. Clothes remained damp after a full cycle.
Repair: Replaced failed heating element WP3387747 from truck stock. Cleared blocked exterior exhaust vent. Completed within two hours of intake call.
Model: 417.81122310
Problem: Loud noise during every cycle. Noise was consistent throughout the drying cycle.
Repair: Found cracked blower wheel hub. Replaced OEM blower housing assembly (137551110). Loud noise eliminated.
Model: 796.41382410
Problem: Front-load washer banging around during operation, especially during the spin cycle.
Repair: Rehung the wash tub on its suspension spring and replaced the rear shock absorber (LG part 383EER3001J). Normal spin operation confirmed.
Model: 402-99032010
Problem: Dryer powered on normally but would not start a cycle.
Repair: Replaced the blown thermal fuse (WP35001087) from truck stock. Dryer starting and running normally — repair completed on the first visit.
Model: 110.68532700
Problem: Dryer would not start despite the control knob working normally.
Repair: Replaced the failed door switch (WP3406107) from truck stock. Dryer starting and running normally — same-day repair.
Kenmore dryers that run but produce no heat commonly have a failed heating element, blown thermal fuse, or failed cycling thermostat. Diagnosis is required to identify the specific cause before replacing parts.
A Kenmore dryer that powers on but will not start a cycle often has a failed door switch or blown thermal fuse. Both are diagnosable and repairable on the first visit when parts are stocked on the truck.
Loud squealing, grinding, or thumping noises in a Kenmore dryer are commonly caused by worn drum rollers, a failed idler pulley, or a damaged blower wheel. The specific noise pattern helps identify the cause.
Excessive banging or vibration during the spin cycle in a Kenmore front-load washer is often caused by a failed suspension spring or worn shock absorber. These components are replaceable.
Kenmore refrigerators that are not cooling properly may have a failed fan motor, a defrost system problem, or a control board issue. Proper diagnosis identifies the specific cause.
A Kenmore dishwasher that leaves standing water after a cycle typically has a failed drain pump, a clogged drain path, or a failed drain solenoid. Diagnosis identifies the specific cause.
We publish real case studies from actual repairs completed in Denver — not stock photos or invented examples.
Our $99 service call fee is applied toward the cost of the repair if you proceed.
Every repair we complete is backed by a one-year parts-and-labor warranty.
We are a veteran-owned local business that has been serving Denver homeowners for over a decade.
We provide Kenmore appliance repair throughout Denver and the surrounding metro area, including:
Call now for same-day service. Our technicians are standing by to help.
